RC Cars

Flysky- FS-GT3C Radio
To turn the light back on at any time, click the Enter button. If the light does not come on, power is turned off.
To select a menu item, click Enter, then slide Enter button left or right to the item you want to select. Then click Enter to make changes.
To charge controller, plug USB cable into back of controller. The LED light beside the antenna will turn red when charging. LED will turn green when fully charged.
	Opening Screen	Displays Model Name. Slide Enter button left or right to view radio voltage.
Model	Model Select (0-9)	Hit Enter button and slide Enter button left or right to select the model to control. The model number will flash. Click Enter again to select model currently displayed.
Name	Name Edit	Hit Enter, slide Enter button left or right to select letter, click End to go to next letter, hit Enter button to save name.
Rev	Servo Reverse	This will reverse the servo directions. Hit Enter, slide Enter* button left or right to select channel (Channel 1 is steering). Click End to move from channel to NOR or REV. Slide Enter button left or right to make the change, hit Enter to save change.
E Point	End Point Adjuster	This will limit the range of the Steering servo. Hit Enter, slide Enter* button left or right to select channel. (Channel 1 is steering). Click End to select the percentage Number. Slide Enter button left or right to get correct percentage number (move steering full left and full right, then change % number until you see the wheels move). Hit Enter to save.
Trim	Steering Trim	This will move the servo left or right which will adjust the front wheels. Hit Enter, slide Enter* button left or right to select channel. (Channel 1 is steering). Click End to Select R##, or L## (N00 is neutral), slide Enter button left or right until centered, click Enter to save. OR click the "ST" Up and Down arrows to change Steering trim, then click "Enter" button to save.
D/R	Dual Rate (Speed Adjustment)	Hit Enter, slide Enter button left or right to select channel. (Channel 1 is steering, Channel 2 is throttle). Hit Enter to save. *To make the car go faster or slower. This will change the throttle percentage. 1. Push Enter button, then slide enter button left or right and select D/R Dual Rate. 2. Press Enter to go to channel Select (The channel number will start blinking) 3. Slide Enter button left or right and select Channel 2. 4. Click End button and the channel number will stop blinking and the percent number will start blinking. 5. Slide Enter button left or right until you get correct speed percentage. 6. Push the Enter** button again to save the setting.
EXP	Exponential	This adjusts the steering sensitivity. For aggressive steering, select 100% .(Channel 1 is steering) Hit Enter, slide Enter* button left or right to select channel. Click End to select percent number. Slide Enter button left or right to increase or decrease, hit End to save. (This makes the steering more sensitive. Negative % will require more movement of the steering wheel to make the wheels turn left or right)
ABS	Auto Brake System	*This will turn on ABS breaking. Hit Enter, channel 2 (throttle) is auto selected (This is the only channel ABS can be used), move left or right to the setting you want to use, hit Enter to save. Options OFF(ABS breaking off), FST(Fast Pulse), NOR(Normal Pulse), SLW(Slow Pulse),

RC Car Receiver Setup
Three Wire Speed Control/Servo Orientation Speed control and Servo Connector: Black wire goes to the outside, white wire goes to the inside.
Receiver Ports: Channel 1 connects to the steering servo Channel 2 connects to the speed controller to control the throttle Batt/Channel 3 is not used